Linear AE-500 Manual do Utilizador

AE-500Telephone Entry& Access ControlSystemPRINTER’S INSTRUCTIONS:INSTR,FACILITY MANAGER,AE-500 - LINEAR P/N: 221000 E - INK: BLACK - MATERIAL: 20

10Wireless Transmitter ProgrammingUp to 500 wireless transmitters can be used with the system. Transmitters can be ordered in pre-programmed blocks of

11Wireless Transmitter Programming (Continued)Activate a TransmitterIf a transmitter has been suspended, it can be activated again with these programm

12System OptionsFor most installations the factory settings for the system will be appropriate. Your installer may have already customized some of the

13System Options (Continued)Speaker Tone on Relay Channel “A” ActivationThe factory setting will not cause the speaker to sound a tone when access is

14System UtilitiesSeveral utility commands are available for the system. Utilities can be used to clear memory, display system information, and contro

15AE-500 OperationRequesting Access with an Entry Code• Residents have up to 40 seconds to key in their entry code.• Up to eight seconds are allowed

Copyright © 2008 Linear LLC 221000 ETroubleshootingSystem completely dead1. Call installation company for service.Buzz on speaker1. Call installati

2ContentsIntroductionThe Model AE-500 Telephone Entry & Access Control System is designed for use as a primary access control device for gated com

3System FeaturesDISPLAYCABINETLOCKOPTIONALPOSTALLOCKSPEAKERKEYPADLIGHTINGKEYPADMICROPHONEYour access control installation companyhas set this master p

4Programming with a ComputerThe AE-500’s built-in programming interface can be accessed on-site (using a separate telephone line) or off-site using a

5Setting up Multiple UnitsThe system supports up to seven AE-500s connected to the same telephone line. Some telephone systems may only support up to

6Programming Over the TelephoneThe system can be programmed using a TouchTone™ telephone. The telephone’s keypad will act similar to the AE-500’s loca

7Programming ReferencePROGRAMMING CONTROLUSAGE KEYSTROKESENTER PROGRAMMING FROM LOCAL KEYPAD . . . . . . . . Press 0 and 2 then MASTER PASSWORDENT

8Resident Data ProgrammingUp to 250 resident names and telephone numbers can be set. Each resident entry is assigned a directory number. The directory

9Entry Code ProgrammingChanging the Entry Code LengthThe factory setting for the entry code length is 4 digits. It can be set to 2-6 digits.1. If not